Steel pipe geometry and shape inspection,Square, card board. Steel pipe surface quality inspection,Steel management performance inspection

Steel pipe geometry and shape inspection:

` Inspection of steel pipe wall thickness: micrometer, ultrasonic thickness gauge, no less than 8 points at both ends and record.

aExamination of steel pipe outer diameter and ovality: caliper, vernier caliper, ring gauge, measure the maximum and minimum points.

b Steel pipe length inspection: steel tape measure, manual and automatic length measurement.

c Inspection of steel pipe curvature: straightedge, level (1m), feeler gauge, thin wire to measure curvature per meter and full length curvature.

d Inspection of bevel angle and blunt edge of steel pipe end face:

Square, card board. Steel pipe surface quality inspection: 100%

` Manual visual inspection: lighting conditions, standards, experience, signs, steel pipe rotation.

aNon-destructive inspection:

Standard: GB/T 5777-1996 Level: C5

Standard: GB/T 7735-2004 Level: Level B

Steel management performance inspection:

`Tensile test: measure the stress and deformation, determine the strength (YS, TS) and plasticity index (A, Z) of the material, longitudinal and transverse sample tube sections, arc, round sample (à10, à12.5) small diameter , Thin-walled large-diameter, thick-walled calibration distance. Note: The elongation of the sample after breaking is related to the size of the sample GB/T 1760

aImpact test: CVN, notch C type, V type, work J value J/cm2 standard sample 10×10×55(mm) non-standard sample 5×10×55(mm) bHardness test: Brinell hardness HB , Rockwell hardness HRC, Vickers hardness HV, etc. cHydraulic test: test pressure, voltage stabilization time, p=2Sδ/D

Steel pipe process performance inspection: ` Flattening test: round specimen C-shaped specimen (S/D>0.15) H=(1+2)S/(∝+S/D)L=40^100mm deformation coefficient per unit length =0.07^0.08 aRing test: L=15mm, no cracks are qualified bFlaring and crimping test: the top center taper is 30°, 40°, 60° cBending test: Can replace flattening test

Tips:

ASTM A500 is a carbon steel cold-formed round section and special-shaped section welded square pipe and seamless square pipe for structural use.

For more information, please visit: https://www.nan-steel.com/news/astm-a500.html

Source: Free Articles from ArticlesFactory.com

ABOUT THE AUTHOR

PR Manager @Nansteel Manufacturing Co.,Ltd